So in this session, we are going to learn how we can train the port authorities from six three seven
nine to any other port.
So if I do, that is how fancy a line here.
You can see that this client is connecting to the server on Port six three seven nine.
And I'm going to close or I'm now going to stop release by typing down, hit, enter and now that this
has been stopped.
So now I'm going to press controls here to come out of this problem and now we need to see the current
position.
So we are right now at this admin and we have a release folder inside this.
I'm going to go inside this folder by typing Service-based Spaceless Hyphen 5.0.
It hit Enter.
And now if I do asifa analogy, you will notice there is a configuration file which is called that is
dot com.
So this is the configuration file where the port resides.
So we need to make changes inside this file.
So I'm going to do very well dot com.
And here you can see there is a default port, which is called six three seven nine.
So I'm going to change this four to six to seven zero, and we need to save it and come out of this
file.
Now, what we need to do is we need to run this hyphens over again to start the server.
And here we also need to specify the configuration file.
Remember last time when we started this, we just type release hyphen server and we type in person.
We did not give part of any configuration file, so that's why it picked up all the default settings.
This time I'm going to say that is not.
Com and we also want to run that is in the background.
So I'm going to do in-person and hit enter.
And now you can see that this has been started and it is running on four six three seven zero now.
So it's going to hit enter.
So come out of this prompt and now we're hearing the problem.
So now if I'm going to connect to this by typing Restifo NCLR, you will notice that we are going to
get error, that it is not connected.
But whereas you only know that we are aware that this is up and we are able to connect to that.
So what is happening here is that when you type this happens here, like by default it tries to connect
to that is on board six three seven nine.
So as you can notice here it is trying to connect to this server on board six to seven nine, whereas
we are running that is on four six three seven zero.
So what we need to do is let's come out of from here by doing control C and then we need to type that
is halfpence here and here.
We need to specify the port on which we want to connect.
So here I'm going to say hyphen P and I'm going to say six three seven zero and hit enter.
This time you can see that we have been successfully able to connect to the server on policy three seven
zero.
Now I'm just going to write some data by using subspace space color and let's put it into it is saying
okay, which means we are able to write data two.
That is also we are going to read the data by doing color.
And Kate, until now, you can see we have got white as the value back, so this means that we have
seen the port default port authorities from six three seven nine.
And now we are connected to that is on Port six three seven zero.
And now that this is running on six three seven zero port.